Digital Weather – Part 1 – The sensor
7 June 2008 General, 1
Switch language: 
To replace my old weatherstation, i orders some one-wire components from www.hobby-boards.com. A very popular one-wire sensor is the DS1820 temperature sensor. This sensor is on my sensor kit from hobby-boars, too. After building the sensor kit (Humidity/Temp/Solar Kit), i needed a good place for it outside. The sensor is placed in a case from hobbyboards. But i wanted some extra protection.
This small case is placed on the south-east side of my house an 1,5 m over the ground. The roof of the house prevent it from direct rain.
The sensor kit is connected over a default RJ-45 networkcable.
See the other side of the wire in part two …
VirtualHosts,OpenBlueDragon with Tomcat 5.5, Apache2 (mod_jk) on Debian Etch Debian Router Installation – Part 3 (VPN)
One Response to “Digital Weather – Part 1 – The sensor”
Leave a Reply
On The Go
- Die Fantastischen Vier – Regensburg 22 December 2011
- Bilder aus Schottland 2011 26 September 2011
- Leaving Scottland 25 September 2011
Hi,
ich habe etwas aehnliches aufgebaut, allerdings mir die Module vom 1-Wire.de Shop dafuer geholt. Da gibts auch Xbee und wohl demnaechst ein 1-Wire LAN Modul – da werde ich wohl auch nochmal etwas umbauen.
Gruss Torro